Shop

CD74HC4067 High Speed ​​CMOS 16-Channel Analog/Digital Multiplexer Breakout Module

SKU: SB-118

In stock

61.00 (Incl. GST)

Specifications:
2V to 6V operation
“On” resistance: 70 Ohms @ 4.5V
6ns break-before-make @ 4.5V
Wide operating temperature range: -55C to 125C

CH341A 24 25 Series EEPROM Flash BIOS USB Programmer with Software and Driver

SKU: S-108

In stock

234.00 (Incl. GST)

Features:

Support 24 EEPROM and 25 SPI flash 8pin or 16pin chip
With 24/25 status indicator lamp
Support USB to TTL conversion support 24EEPROM and 25 SPI flash 8pin/ 16pin chip
Recognize 25 series chip automatically
Supports download STC series procedure of single chip
SPI pin to support expanding the utility
STC microcontroller supports a full range of program download
Support expanding the utility by SPI pin
With SOP8 SOP16 to DIP8 converter board
Supports Windows XP, Vista, Win7 and Win8 (32/64bit) system
Provide 5V-3.3V power supply output

CJMCU MCP4725 I2C DAC Breakout Development Board

SKU: S-159

In stock

127.00 (Incl. GST)

Feature:

12-bit resolution
I2C Interface (Standard, Fast, and High-Speed supported)
Small package
2.7V to 5.5V supply
Internal EEPROM to store settings

CJMCU TCA9548A I2C 8 Channel Multiple Extensions Development Board

SKU: S-139B

In stock

75.00 (Incl. GST)

Features :
Low Standby Current.
1-to-8 Bidirectional Translating Switches.
I2C Bus and SMBus Compatible.
5-V Tolerant Inputs.
Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II.

CJMCU-2551 MCP2551 CAN Protocol Controller High-speed Interface Module

SKU: SB-113

In stock

249.00 (Incl. GST)

Features:
Supports 1 Mb/s operation
Suitable for 12V and 24V systems
The externally-controlled slope for reduced RFI emissions
Detection of ground fault (permanent Dominant) on TXD input
Power-on Reset and voltage brown-out protection
An unpowered node or brown-out event will not disturb the CAN bus
Low current standby operation
Protection against damage due to short-circuit conditions (positive or negative battery voltage)
Protection against high-voltage transients
Automatic thermal shutdown protection
Up to 112 nodes can be connected
High-noise immunity due to differential bus implementation
Temperature ranges:
– Industrial (I): -40°C to +85°C
– Extended (E): -40°C to +125°C

CJMCU-4051 74HC4051 8 Channel Analog Multiplexer/Demultiplexer Breakoutut Board for Arduino

SKU: SB-117

In stock

79.00 (Incl. GST)

Specifications

Wide Analog Input Voltage Range: +/-5V
Low “ON” Resistance: 80 ohm (type) at Vcc = 4.5V; 70 ohm (type) at Vcc = 6.0V; 60 ohm (type) at Vcc = 9.0V.
Logic Level Translation: to enable 5V to communicate with +/-5V analog signals
Board Size: 30 x 19 mm

CJMCU-75 LM75B LM75 Temperature Sensor Module Digital I2C Breakout

SKU: S-146

In stock

155.00 (Incl. GST)

Features:

I2C bus interface, the device address 7 slave address 1001xxx, can expand external eight devices on the same bus;
11bit ADC provides a temperature resolution of 0.125’C;
Programmable temperature threshold and hysteresis set points;
In order to reduce power consumption, the current consumption in shutdown mode is the only 1.0uA;
On power-up, the device can be used as a stand-alone temperature controller

CJMCU-9833 AD9833BRMZ Programmable Sine Triangular Square Waveform Generator Module

SKU: S-057

In stock

495.00 (Incl. GST)

Working voltage: 2.3V-5.5V.
Working temperature range: -40 ~ + 105.
Onboard 25MHZ (accuracy of 50ppm) active crystal.
On-board high-speed amplifiers

CJMCU-GUVA-S12SD Sunlight Ultraviolet Ray Intensity UV Sensor

SKU: S-110

In stock

239.00 (Incl. GST)

Specifications:
Power supply voltage of 2.5 V ~ 5 V
Low power consumption
Wide detection range: 240 nm to 370 nm
Wide Angle: 130 degrees
Schottky type photosensitive diode
Good linear response
High sensitivity

CJMCU-TEMT6000 An Ambient Light Sensor

SKU: S-052

In stock

100.00 (Incl. GST)

Features:
AEC-Q101 qualified
High photosensitivity
Near-Human Eye Spectral Response
Scalable Output Voltage
Adapted to human eye responsivity
Lead (Pb)-free reflow soldering

CP2102(6-pin) USB 2.0 to TTL UART serial converter

SKU: SB-107b

In stock

110.00 (Incl. GST)

Specifications:
Stable and reliable chipset CP2102.
USB specification 2.0 compliant with full-speed 12Mbps.
Standard USB type A male and TTL 6pin connector.
All handshaking and modem interface signals.
Baud rates: 300 bps to 1 Mbps.
Byte receives buffer; 640 bytes transmit buffer.
Hardware or X-On/X-Off handshaking supported.
Works with existing COM port PC Application

Crocodile Clips Small (1 Pair)

SKU: SB-072

In stock

20.00 (Incl. GST)

Features:
Length: 50 mm
Weight: 8g Each
Color: Red and Black
Insulating Material: plastic